For time:
5 rounds:
10 pushups
100 jumping jacks
10 pushups
100 mountain climbers (50 each leg)
Monday, January 25, 2016
Wednesday, January 20, 2016
Week 2 - WOD 2 Gathering Thrust
![]() |
| Do your job and do the WOD |
Warm-up:
3 Rounds of
10 Air Squats
10 Spider Lunges
10 Push Ups
10 Alt Samson Lunges
Then
10 Push Ups
10 Alt Samson Lunges
Then
2 Rounds of
Death Stretch (30 seconds back, 30 seconds forward each side)
1 Minute Squat Hold
Strength:
Prep work
1 x 10 (just bar)
Take 12-15 min. to work up to your 3 rep thruster weight. (weight should be heavy but one that allows good form (as always)
Working sets:
5 x 3 Heavy Thursters + AMRAP Pull-ups (rest as needed between rounds)
Pull ups are to be performed immediately after each set of Thursters. Scaling options include Chest to bar, Chin over bar, Band Assisted (still chin over bar) or Negatives (beginning from a chin over bar position)
Notes on Thrusters:
It is a fact
that the technique for the thruster is much more difficult than for either the
front squat or the push press alone. This is because the ideal front squat uses
a different elbow position than the ideal push press. The front rack position
is hard enough, but in the thruster, a lifter must not only have a solid front
rack, but then be able to transition, mid-lift, into a solid push press
position. Thrusters are often used in CrossFit workouts in high rep schemes,
but going for weight can really help determine where you are weakest in the
movement, areas that are perhaps covered by brute strength or speed when done
at lighter weight for high volume. It’s tempting to want to concentrate on the
over-head part, but remember: without a stable and well-controlled front squat,
you may very well not even make it to the overhead part.
Squat Cycle Week 2 - WOD 1- Mr. Squat
Week 2 begins with our good friend, Mr. Squat.
![]() |
| Our friend Mr. Squat |
1RM=one rep max
Prep Sets
1 x 10 (just bar)
1 x 10 at 30-35% 1RM
1x 8 @ 50% 1RM
1 x 6 @ 65% 1RM
Back Squat 3 x 6
@ 75%
Accessory:
10 x 2 Sumo DL Speed
Pulls
Working in pairs if possible, with minimal rest between sets, use a weight that is
roughly 50-60% of your 1RM. The focus for speed pulls is on making every rep as
fast as possible, not on moving heavy weight as fast as you can (it’s subtle,
but easy to spot). You should be able to set up to the bar, set-up, and then
squeeze the bar off the floor, exploding upwards into the upright and extended
position. Don’t forget however, that this must still be a controlled movement.
Met-Con:
For time:
5 rounds
5 burpees + 3
shuttle run (out and back 10 meters each way),
Notes on the squats:
Although 10% heavier than last week, this emphasis should still be on a nice smooth movement. The weight will be heavier, but if you find yourself grinding through the lift, or if you find a sticking point that really slows down the movement, assess what may be causing that (other than the weight). Common faults include:
- collapsing into the bottom of the squat, or rushing the concentric portion of the squat (lowering the weight), which strips the body of tension and actually makes it more difficult to stand up (this includes trying to “bounce” the weight up from the bottom position);
- letting the knees cave in, which compromises back stability and will often cause you to pitch forward onto your toes;
- allowing the chest to deflate or sag – remember, while we are trying to stand up with the weight, you must drive your chest up with the weight as well, or your hips will rise faster than your torso (this will cause you to pitch forward and lose momentum, stalling the movement as you attempt to regain upper body position); and,
- not squatting deep enough. Remember, the crease of the hips should be at least at the same level as your knees, although it’s preferable that the hip-crease be slightly below the knees. The fix is rather simple (so long as your depth issue isn’t related to one of the faults above), and that’s to simply go deeper.
Thursday, January 14, 2016
Week 1 - WOD 3 - San Andreas Metcon
Warm-Up
3 Rounds of
20 Jumping Jacks
10 Spider Lunges
5 Dolphin Push-ups
20 Squats
10 Supine Scorpion
5 Plank to Squat
Met-Con
3 Rounds of
AMRAP 3 Minutes
12 Box Jumps
15 Push-Ups
1 Minute Rest12 Box Jumps
15 Push-Ups
AMRAP 3 Minutes
12 KB Swings
15 Sit Ups
1 Minute Rest12 KB Swings
15 Sit Ups
1 Minute Rest
Week 1 WOD 2 - Pullup and Push Press Building Blocks
WARM UP
3 Rounds of
12 Jumping Jacks
6 Spider Lunge w/ Reach Up
12 Push Ups
6 Supine Scorpion
12 Jumping Jacks
6 Spider Lunge w/ Reach Up
12 Push Ups
6 Supine Scorpion
Strength:
4 x 6 Mixed Grip Strict Pull
Ups+ 12 Push Presses @ 65-75% 1 RM
Accessory
3 Rounds, NFT, of
10-15 DB Wrist Extension Prone Hollow Hold (scale to plank hold)
10 DB Powell Raises
20 Flutter Kicks
3 Rounds, NFT, of
10-15 DB Wrist Extension Prone Hollow Hold (scale to plank hold)
10 DB Powell Raises
20 Flutter Kicks
Everyone is encouraged to do as many strict
pull-ups as possible, regardless of wether or not they can get 6. If pull-ups are not the cards, or when they
finally gave out, the next step down the scale is negatives, but never more
than 3 at a time. If the negatives aren’t working – i.e., dropping too fast –
the final step down on the scale ladder is incline bar rows. Weight for the
push-press is suggested as anywhere from 65-75% of your athlete’s max weight.
A quick note about form: while we often
concentrate on pushing the weight up with our shoulders, don’t forget that once
the weight is overhead, it’s imperative that we stabilize it. This requires the
use of our entire body; pushing the head through the arms and driving the
shoulders up towards the ears are essential, but that’s not enough. To really
stabilize, we need to remember to tighten up the lower half of our bodies by
squeezing our abs and glutes, thereby locking in our core. This creates a nice
straight and stable mid-line from the barbell through the middle of our feet.
| Here, you can see that John’s using active shoulders and has pushed his head through to ensure the weight is overhead, but because his abs and glutes aren’t engaged, his back is over-arched, creating empty space between the bar and his feet |
| Two reps later, after a quick reminder, John’s still using active shoulders and pushing his head through, but he’s also engaged his core, creating a nice stable body position under the weight. As it often goes with lifting, it doesn’t take a lot to make a big difference. Kudos to John for listening and applying the cues within the same set! |
Subscribe to:
Posts (Atom)




