Wednesday, January 20, 2016

Week 2 - WOD 2 Gathering Thrust

Do your job and do the WOD



Warm-up:

 3 Rounds of
 
10 Air Squats
10 Spider Lunges 
10 Push Ups
10 Alt Samson Lunges  
Then

2 Rounds of
Death Stretch (30 seconds back, 30 seconds forward each side)
1 Minute Squat Hold

Strength:

Prep work

1 x 10 (just bar)

Take 12-15 min. to work up to your 3 rep thruster weight.  (weight should be heavy but one that allows good form (as always)


Working sets:


5 x 3 Heavy Thursters + AMRAP Pull-ups (rest as needed between rounds)


Pull ups are to be performed immediately after each set of Thursters.  Scaling options include Chest to bar, Chin over bar, Band Assisted (still chin over bar) or Negatives (beginning from a chin over bar position)



Notes on Thrusters:


It is a fact that the technique for the thruster is much more difficult than for either the front squat or the push press alone. This is because the ideal front squat uses a different elbow position than the ideal push press. The front rack position is hard enough, but in the thruster, a lifter must not only have a solid front rack, but then be able to transition, mid-lift, into a solid push press position. Thrusters are often used in CrossFit workouts in high rep schemes, but going for weight can really help determine where you are weakest in the movement, areas that are perhaps covered by brute strength or speed when done at lighter weight for high volume. It’s tempting to want to concentrate on the over-head part, but remember: without a stable and well-controlled front squat, you may very well not even make it to the overhead part.



1 comment:

  1. Tough time staying on heels until hips and legs were extended. Sam and Chris used 95 lbs for the working sets.

    ReplyDelete